Laterna 4 Outdoor Black PIR Wall Light 22469
Q1: Does the pir on the bottom swivel?
A1: Yes, it is mounted with a ball joint to enable adjustment of the detection field.
Q2: Does the light only come on at night ?
A2: Yes, the light is only activated when the light outside reaches a certain level and the sensor detects movement.
Q3: Can you wire a slave light direct from this light? (the light that i want to replace has a switched live out to a slave, As well as the permanent live feed in. If this one can't be wired the same way, Some extensive rewiring will be needed.)
A3: Unfortunately you cannot control a slave off the sensor on this light, its set to just run the light it is connected to
Q4: Is it possible as a layman to turn the 22469 over so the pir is on the top of the fitting and the lamp under the bracket? As the 22467
A4: I have checked with the manufacturer of this light and they would not recommend doing this as the sensor would not be protected and it would compromise the Ingress protection rating.
You could buy the 22467 and a separate PIR sensor could be added such as the one below.
Is1 Pir Sensor
Q5: Hi, Please can you let me know the width of the light fitting that attaches to the wall, I am looking for a lantern security light that is no wider than 9cm? Thank you
A5: The widest part on the back-plate measures 110mm
Q6: Can the light also be operated with a switch to override the sensor when required so it stays on indefinitely until the switch is turned off again and the light goes back to sensor operation
A6: This product has no override function. If you type in "manual override" in our search, it will bring up all the lights with this function. They do only override for 4 hours though
- Price Promise
Lowest Price Guaranteed
Normally Within 7 Days
- Confirmed In Stock
With The Manufacturer
Laterna outdoor cast aluminium PIR sensor wall light.
This exterior fitting has a black finish and clear glass side panels positioned all around the lamp, the clear panels allows the full brightness of the bulb to shine through.
The sensor has a 120 ° angle and an 8 meter range and can be set from 5 seconds- 540 seconds.
Requires 1 x 60 watt E27 ES bulb that is not included. Back plate dimensions: 140mm height x 115mm width.
This is part of the Lanterna 4 Range.
Class 1 Requires an Earth..
Light Source: ES-E27 Incandescent.
Alternative Light Source: Retrofit LED Bulbs are also available.
Dimming Info: Not Suitable For Dimming.
Warranty Period: Three Years.
Ingress Protection Rating: IP33.
- Height: 425mm
- Width: 235mm